This 23-piece Wheels Mfg. drift set is used to install 10mm and larger inside diameter sealed bearings, using a press with 3/8" diameter rod - Includes open bore and over axle drifts for 6802, 6901, 6902, 6903, 6000, and 6001 bearings - 10mm ID hole, for use with Wheels Manufacturing PRESS-1 or PRESS-4 bearing press handles
This do-it-all universal bottom bracket press is designed to press in all current Wheels Mfg. bottom brackets. Economical and easy to use, this tool is made up of two machined aluminum handles, a 1/2-inch threaded rod, and two machined aluminum drifts. Each drift is machined with multiple steps to fit common bottom bracket shell and bearing diameters. No more searching for the correct size drifts and parts—just match up the drift to your frame's BB shell size and your bottom bracket's bearing size, and press away. - Zinc-plated 1/2-inch diameter threaded rod resists bending, allowing for the cups to align and press in straight - Drifts can also can be used as a frame bottom bracket shell sizing guide - Machined aluminum handles and drifts - Red anodized drifts and handles - Steps on drift are marked with diameter sizes - Works with BB shells up to 132mm wide - Includes two universal BB drifts
- Anodized aluminum construction. Includes mounting hardware - Measures threads for all cones, locknuts and axles - Metric measurement on one side and Standard on the other side
BB30 service kit for SRAM DUB cranks. - Includes (2) Enduro 6806/29 ABEC-3 sealed bearings and 2 retaining clips - Bearing Dimensions: OD: 42mm / ID: 29mm / Width: 7mm - Enduro ABEC-3 bearings - Use with SRAM DUB cranks Note: SRAM DUB cranksets are not designed to work in 68mm or 73mm wide shells with inboard bearings. Use only if your frame is a direct-fit bearing system, and the BB shell width is 86.5mm or wider.
Wheels Manufacturing open bore adapters are used to press sealed cartridge bearings into place. The adapters are machined with one step to correspond to the bearing OD, which fits in to the center of the sealed bearing and an outside diameter to accommodate the bearing's outer diameter. Size: [Bearing inner diameter] x [Bearing outer diameter] Note: If only one dimension is given, that is the outer diameter of the adapter, with no inner diameter step
Page 1 of 1